Influences of different plant spacing and application times of growth regulator (mepiquat chloride) on the internode length of cotton-

ABSTRACT

An experiment was conducted at Cotton Seed Multiplication, Training and Research Farm, Sreepur, Bangladesh during 2016-2018 to evaluate the response of cotton plant height to different plant spacing, concentration as well as time of application of mepiquat chloride (MC) as growth regulator. Plant spacing were  like 45 cm × 30 cm, 60 cm × 20 cm, 60 cm × 30 cm, 60 cm × 40 cm, 75 cm × 30 cm, 75 cm × 40 cm, 90 cm × 10 cm and 90 cm × 45 cm; MC was sprayed @ 1.0 ml L-1 water at 25, 50, 75, 100 and 125 days after emergence (DAE) in 2016 whereas  @ 1.0, 2.0, 3.0 and 4.0 ml  L-1  water at 25, 50 and 75 DAE for each conc. in 2017. During 2008 MC sprayed @ 2.0 and 4.0 ml L-1 water at 25 DAE, 2.0 and 4.0 ml L-1 water  at 50 DAE,  2.0 ml L-1 water  at 25 as well as 50 DAE in 2018 along with water sprayed  as control. The shortest internodes (3.00 cm) was obtained from 1ml MC L-1 water at 25 DAE with medium plant spacing 60 cm ×   30 cm and the longest (6.67) was from water treatment with 90 cm × 45 cm spacing. So, cotton cultivation in Sreepur, Gazipur areas may be accelerated with foliar application of mepiquat chloride @ 1 ml L-1 water at 25 DAE along with plant spacing of 60 cm x 30 cm for higher yield and quality.

Key words: MC, spacings, foliar application, internode length

Genetic diversity analysis for different agro-morphological characters of tossa jute

ABSTRACT

The genetic diversity was studied for eleven growth and yield related characters in fifty three genotypes of tossa jute which were collected from the Gene Bank of Bangladesh Jute Research Institute (BJRI), Dhaka. The experiment was laid out in a Randomized Complete Block Design (RCBD) with three replications. The highest intra-cluster distance was estimated for cluster IV (0.338) which consisted of fourteen genotypes followed by cluster III (0.330) for eighteen genotypes, cluster V (0.297for seven genotypes and cluster II (0.284) for eleven genotypes. Cluster III contained the largest number of genotypes (eighteen) followed by cluster IV (fourteen) and cluster II (eleven), respectively. The inter cluster distance was maximum between cluster I and V (20.616) followed by the distance between clusters I and IV (18.405), I and III (14.857), II and V (10.984), I and II (10.277) indicating that the genotypes grouped within these cluster were highly divergent from each other. The least genetic distance at inter-cluster level was observed between cluster IV and V (2.871), followed by the distance between clusters III and IV (4.296), and between II and III (4.584) indicating that the genotypes of these clusters were genetically closely related. The maximum contribution was paid by the character, base diameter (0.5335) followed by green wt. without leaves (0.4790), green bark thickness (0.4672) and plant height (0.3858).

Key words: Genetic diversity, clustering, tossa jute.

Introduction

 Information on genetic divergence among the parental materials is vital to plant breeder for an efficient choice of parents for hybridization. More diverse parents are the chances for high heterotic F1S and broad spectrum of variability in segregating generation (Murty and Arunachalam, 1966). However, evaluation of genetic diversity is important to know the source of gene for a particular trait within the available germplasm (Tomooka, 1991). In the past, very few researches have been carried out related to morpho–agronomic diversity and relationships in jute with diverse geographical origins. Plave and Sinha (2005) used 6 accessions of C. capsularis L. and 7 accessions of C. olitorius L. for their study. Recently, Benor et al. (2012) used only C. olitorius L. species to study genetic diversity and relationships inferred from molecular and morphological data. Moreover, multivariate methods particularly principal component analysis (PCA) have proven to be useful for characterizing, evaluating and classifying germplasm when a large number of accessions are assessed for several characteristics of agronomic importance (Badenes et al., 2000). Rapid genetic improvement of crop depends on the availability of sufficient genetic diversity, which could be selected and combined in various forms to produce reasonable improvement (Wani, 2011). Hence in the present study the genetic diversity was studied for eleven growth and yield related characters in fifty three genotypes for further development and creation of higher diversity in tossa jute.

Comparative returns among farmers’ alternate cropping patterns in comparison with existing farmers’ practices in Jashore region of Bangladesh

ABSTRACT

The experiment was conducted at the Jute Research Sub-station, BJRI in Jashore during the cropping season in 2020 to improve an economically sustainable and profitable cropping pattern over the existing pattern. Four alternate cropping patterns viz. Boro-jute-T. aman (ACP1); Boro-T. jute-T. aman (ACP2); Boro/jute-   T. aman (ACP3) and Boro-jute/B. aman (ACP4) were introduced against the existing farmers’ cropping pattern Boro-fallow-T. aman (FCP). The experiment was conducted with three replications following RCB design. The highest rice equivalent yield (19.71 tha-1) was recorded from the cropping pattern Boro/jute-      T. aman (ACP3) followed by ACP2 (19.36 tha-1), ACP1 (19.33 tha-1) and ACP4 (18.86 tha-1). The farmers-managed cropping pattern Boro-fallow-T. aman yielded the lowest rice equivalent yield (12.41 tha-1). The gross return and gross margin in the alternate cropping patterns were higher than those in the existing cropping pattern. In comparison to the farmers’ pattern as cash cost basis, the gross margin was boosted by 55–60% in the farmers’ alternate pattern. The marginal benefit cost ratio was found to range from 2.16 to 2.77. Therefore, for improved crop productivity and profitability, farmers in the Jashore region could adopt alternate cropping pattern on their medium-high land where the lands may fallow after boro harvesting.

Key words: Farmers’ alternate cropping pattern, MBCR, rice equivalent yield, relay, T. jute.

Efficacy of different fungicides for managing botrytis grey mould of chickpea

ABSTRACT

Efficacies of different fungicides were evaluated in managing botrytis grey mould of chickpea. This field experiment was conducted in two sub-station of Bangladesh Institute of Nuclear Agriculture (BINA): Magura and Ishwardi. Fungicides increased seed germination over control in field condition both in Magura and Ishwardi. Seed germination percentage in Magura and Ishwardi was higher in Bavistin treated plots 95.25% and 93.87% respectively. Fungicides treated plots showed lower disease incidence over control. In Magura incidence of botrytis grey mould of Binachola-3 was recorded highest in control plots (5.91%) and lowest in Bavistin (2.04%). In Ishwardi lowest incidence was recorded at Bavistin (3.15%) and highest was recorded in control plots (6.54%).  Disease incidence reduction over control for Magura and Ishwardi were 65.48% and 51.77% respectively. Plant height, plant stand, number of pod per plant, number of seed per pod, unfilled pod per plant, seed weight per plant and dry plant weight was observed higher in treated plots over the control plots both in Magura and Ishwardi. Bavistin treated plots resulted the lowest botrytis grey mould incidence with higher yield components than the non-treated plots. Others treatments such as Secure, Biofungicides, Ridomil gold, Rovral, nativo, Dithane M-45 also showed significantly the better results (in reducing) for management of botrytis grey mould of chickpea than the control plots in the fields.

Key words: Fungicides, efficacy, botrytis grey mould and chickpea

Effect of plant growth regulator (gaba) on growth and yield of chilli

ABSTRACT

An experiment was conducted to evaluate the application of plant growth regulator (GABA) on the variation in growth, yield and yield attributes of chilli cv. Narikalkhola under the regional condition of Mymensingh, Bangladesh. The experiment comprised of three levels of GABA viz. 1, 2, and 3 mgL–1 and fresh water sprayed as control on chilli plant at 30 DAT. The experiment was laid out in a Randomized Complete Block Design (RCBD) with three replications. The application of GABA significantly increased the plant height, number of branches and leaves plant–1, canopy area, root length, weight of root, stem and leaf as well as the total dry mass over control. GABA @ 3 mgL–1 had the most effective approach for obtaining the highest significant impact on green fruit yield due to increased number of fruits plant–1 and fruit size followed by      2 mgL–1 with same statistical rank while control treatment was the least significant impact on the above traits.

Key words: Chilli, GABA, growth, yield       

Introduction

Chilli (Capsicum annuum L.) belongs to the genus Capsicum and the family Solanaceae. Chilli is native of Central America and the West Indies but spread quickly throughout the tropical countries after the discovery of America and the West Indies (Pruthi, 1993). It is virtually an indispensable item in the kitchen for everyday cooking. The red chilli fruit contains 15.9% protein, 31.6% carbohydrate, 50 mg/100g vitamin-C and small quantities of vitamin A, B and E. In Bangladesh, chilli ranks 1st in area (349 thousand acres) and 2nd in production (2,54,000 m tons) among the spices (BBS, 2007). Chilli is widely grown in all parts of the country and its winter production covers about 70% of the total production (BBS, 2007). But the average yield of chilli in Bangladesh is very low compared to other leading chilli growing countries in the world (FAO, 2005) due to improper cultivation management practices. Improvement of existing spice crops through proper cultural management practices need urgent attention to meet increasing demand of edible spices for the fast growing population of Bangladesh. That is why, special attention should be made for increasing the yield per unit area by adopting improved technologies and management practices. In this connection, use of plant growth regulators (PGRs) might be a useful alternative to increase crop production. Many developed countries like Japan, China, Poland and South Korea etc. have long been using PGRs to increase crop yield. PGRs are being used as an aid to enhance crop yield (Nickell, 1982). Among the PGRs, GABA is a new plant growth regulator that may have many uses to modify the growth, yield and yield attributes of plant. GABA contains 1% GA3 and 0.05% STC (Kamuro et al., 2001) which have capability to enhance the growth and yield attributes in sesame (Islam, 2007), in mungbean (Begum, 2006), in rice (Afroz, 2005), in onion (Rahman, 2005) and in soybean (Rahim, 2005). Research works with GABA on growth, yield attributes and yield of chilli are scanty. So, there is ample scope of conducting research with GABA for increasing yield of chilli. Considering the above facts, the present research work was undertaken to observe the effect of GABA on growth, canopy structure, yield attributes and yield in chilli and to find out the effective dose of GABA for getting the higher yield.

Yield trails conducted at different agro-ecological zones for selecting the best strains of desi jute (Corchorus capsularis L.) in Bangladesh

ABSTRACT

The experiment was conducted at five regional stations viz. Jute Agriculture Experiment Station (JAES), Manikgonj; Rangpur; Chandina; Faridpur and Kishoregonj of BJRI in 2017. The quantitative (plant height, base diameter, green weight with and without leaves, fibre weight and stick weight etc.) data were recorded 120 DAS. Analysis of variance revealed that significant differences among the treatments. Plant height, fibre yield and stick yield are relatively higher in Faridpur regional station than other part of the country. Also, out of seven progenies, C-4339 yielded comparatively better than other progenies and check variety and also observed that the fibre and stick yield increased with the increasing of plant height and base diameter. 

Key words: Deshi jute, progeny, strains, genotype.

 

Introduction

 

 Deshi jute (C. capsularis L.) jute cultivation needs to be increased in future for its great demand to the jute industries of the country (Khatun et al., 2010). Its fibre is a substitute for non-biodegradable fibres with a large range of commercial applications (Benor et al., 2012; Islam, 2013). Jute accounts for about 5 percent of the foreign currency earnings from export. It appears from the recent record that the area under jute is declining; the crop is being pushed more and more to the marginal lands. There are many constrains to higher and stable yield of quality fibre. In this situation, it is important to develop new and promising deshi jute variety for quality fibre to make the jute cultivation as profitable enterprises around the country. Keeping these objectives in mind seven new promising progenies were derived through nine parent diallel crosses and subsequent selection and tested for assessment of their yield and other attributes under different agro-ecological conditions. An objective of this experiment was to develop breeding lines with distinct character, higher yield and quality fibres of deshi jute in Bangladesh.